Quote Toolbox/Tank Combo Information Sheet

Our Toolbox/Tank Combos are usually located between the front of the bed (end closest to the cab) and the wheel well, go from side to side in the bed of the truck, and are bed height. Sometimes standard sizes just don’t fit your needs and a custom tank is needed. KSH manufactures all of its tanks so quoting and making a custom toolbox/tank combo for your truck is a simple matter of your providing us with some information.

Measure the available space in your truck to determine the width, height, depth, etc of a toolbox/tank combo unit that will fit in your vehicle. If you have a cover over your truck we will need to know the maximum distance from the bed of the truck to the lowest part of the cover. Use these measurements to design a Toolbox/Tank Combo for your truck by filling in the boxes on the drawing below that best fits the general appearance of the unit you need.  Please be sure to provide the contact information so we can contact you with a quote and any questions we may have.

If you are purchasing a Toolbox/Tank Combo unit and need to provide information on the types and locations of the fittings, please fill in the dimensions of the tank on the appropriate drawing.  Print the page and then note the locations of the fittings on the printed drawing. Please label the fitting as to what it is such as fill pipe.  Give the distance from the center of the fitting to one long end and one short end of the tank.  The drawing can be faxed to (928) 680-7379 or emailed to info@kshfuelproducts.com.  If you have any questions don’t hesitate to give us a call at (928) 680-6610.

Get a quote below.


** Please Note: the lid of the box will add an additional 1.5 inches from side to side from the dimension of what the tank is. Make changes to the tank size if necessary.
Required Vehicle Information:

Providing a VIN Number allows for the most accurate information for your quote.

If you have a cover specify type and dimensions below

Height between lowest point of tonneau (including hardware) and bed of truck

Distance between rails for cover if applicable

Distance between inside brackets for cover if applicable